Aeromonas and Pseudomonas: antibiotic and heavy metal resistance species from Iskenderun Bay, Turkey (northeast Mediterranean Sea)

We studied the susceptibility patterns to 15 different antibiotics and six heavy metals in Aeromonas spp. and Pseudomonas spp. isolated from Iskenderun Bay, Turkey (northeast Mediterranean Sea). A high percentage of Aeromonas isolates showed resistance to cefazolin (66.6%) and trimethoprim–sulphamethoxazole (66.6%). Amongst the Pseudomonas isolates, there was a high incidence of resistance to nitrofurantoin (86.2%), cefazolin (84.8%) and cefuroxime (71.7%). Most isolates showed tolerance to different concentrations of heavy metals, and minimal inhibition concentrations ranged from 25 to >3,200 μg/ml. The Aeromonas spp. and Pseudomonas spp. showed high resistance to copper of 98.3% and 75.4%, respectively, and low resistance to lead of 1.7% and 7.2%, respectively. Our results show that antibiotic and heavy metal resistant Aeromonas spp. and Pseudomonas spp. were widespread in Iskenderun Bay in 2007 and 2008. The increasing presence of antibiotic and heavy metal resistant Aeromonas spp. and Pseudomonas spp. may become a potential human health hazard.     

Comparison of some quality properties of soils around land-mined areas and adjacent agricultural fields

When agricultural lands are no longer used for agriculture and allowed to recover its natural vegetation, soil organic carbon can accumulate in the soil. Measurements of soil organic carbon and aggregate stability changes under various forms of land use are needed for the development of sustainable systems. Therefore, comparison of soil samples taken from both agricultural and nearby area close to land-mined fields where no agricultural practices have been done since 1956 can be a good approach to evaluate the effects of tillage and agriculture on soil quality. The objective of this study was to compare tillage, cropping and no tillage effects on some soil-quality parameters. Four different locations along the Turkey–Syria border were selected to determine effects of tillage and cropping on soil quality. Each location was evaluated separately because of different soil type and treatments. Comparisons were made between non-tilled and non-cropped fallow since 1956 and adjacent restricted lands that were tilled about every 2 years but not planted (T) or adjacent lands tilled and planted with wheat and lentil (P). Three samples were taken from the depths of 0–20 and 20–40 cm each site. Soil organic carbon (SOC), pH ,electrical conductivity, water soluble Ca⁺⁺, Mg⁺⁺, CO₃^-2{\rm CO}_{3}^{-2} and HCO₃^-{\rm HCO}_{3}^{-}, extractable potassium (K⁺) and sodium (Na⁺), soil texture, ammonium (NH₄⁺{\rm NH}_{4}^{+}–N) and nitrate (NO₃–N), extractable phosphorous and soil aggregate stability were determined. While the SOC contents of continuous tillage without cropping and continuous tillage and cropping were 2.2 and 11.6 g kg⁻¹, respectively, it was 30 g kg⁻¹ in non-tilled and non-planted site. Tillage of soil without the input of any plant material resulted in loss of carbon from the soil in all sites. Soil extractable NO₃−N contents of non-tilled and non-cropped sites were greatest among all treatments. Agricultural practices increased phosphorus and potassium contents in the soil profile. P₂O₅ contents of planted soils were approximately 20 to 39 times greater than those of non-tilled and non-cropped soils at different sites. FTIR spectra showed that never tilled sites had greater phenol, carboxylic acid, amide, aromatic compounds, polysaccharide and carbohydrates than other treatments.     

Microbiological and performance evaluation of sequencing batch reactor for textile wastewater treatment

This study focused on laboratory-scaled and real-scaled treatment plant performances and microbiological investigations for the optimum treatment of textile industry wastewater performed with sequencing batch reactor (SBR). As a result of experimental studies of laboratory-scaled SBR treatment unit, optimum treatment efficiency was taken from 0.5 h filling to 1.5 h. reaction to 1.5 h. settlement to 0.5 h. discharge-idle periods. Average chemical oxygen demand (COD) removal efficiency of SBR of laboratory-scaled textile industry was 75%, whereas average turbidity and color removal (coloration number [RES, m(-1)] 586 nm) efficiencies were 90% and 75%, respectively. Optimum reaction and settlement periods were used in a real-scaled plant, and plant efficiency was examined for parameters such as COD, phenol, pH, mixed liquor suspended solids (MLSS) and sludge volume index (SVI). In this study, optimum reaction and settlement periods for treatment of textile industry wastewater were determined within a SBR in a laboratory-scaled plant. These reaction and settlement periods were verified with the measurement of COD, color, and turbidity parameters. Floc structure and protozoa-metazoa species of activated sludge in a SBR were also determined. Optimum reaction and settlement times were used in a real-scaled plant, and plant efficiency was examined for COD, Phenol, pH, MLSS, and SVI parameters. The corresponding values were found as appropriate, acceptable, and meaningful because of variance value of statistical analysis. Protozoa and metazoan in the activated sludge in the laboratory-scaled plant were investigated. Peranema sp., Epistylis sp., Didinium sp., Chilodonella sp., Opercularia sp., Vorticella sp. as protozoa species and Habrotrocha sp., Philodina sp. as metazoa species were determined.     

Degradation of the pharmaceutical metronidazole via UV, Fenton and photo-Fenton processes

Degradation rates and removal efficiencies of Metronidazole using UV, UV/H2O2, H2O2/Fe2+, and UV/H2O2/Fe2+ were studied in de-ionized water. The four different oxidation processes were compared for the removal kinetics of the antimicrobial pharmaceutical Metronidazole. It was found that the degradation of Metronidazole by UV and UV/H2O2 exhibited pseudo-first order reaction kinetics. By applying H2O2/Fe2+, and UV/H2O2/Fe2+ the degradation kinetics followed a second order behavior. The quantum yields for direct photolysis, measured at 254 nm and 200-400 nm, were 0.0033 and 0.0080 mol E(-1), respectively. Increasing the concentrations of hydrogen peroxide promoted the oxidation rate by UV/ H2O2. Adding more ferrous ions enhanced the oxidation rate for the H2O2/Fe2+ and UV/H2O2/Fe2+ processes. The major advantages and disadvantages of each process and the complexity of comparing the various advanced oxidation processes on an equal basis are discussed.     

Investigation of trace elements in agricultural soils by BCR sequential extraction method and its transfer to wheat plants

In this study, soil samples were collected from Edirne, Turkey in both summer and winter seasons and subjected to the modified Community Bureau of Reference (BCR) sequential extraction procedure in order to investigate the chemical partitioning of metals in soils and to predict heavy metals uptake by wheat grains which grown at the same soils. The samples were subjected to a three stage extraction procedure proposed by the BCR. The three phases that were separated out in the following order: (1) carbonate, exchangeable, (2) Fe?CMn oxides, and (3) organic matter. Metal concentrations of soil fractions and grain samples were determined by inductively coupled plasma atomic emission spectroscopy. The wheat samples were prepared to analysis using microwave acid digestion procedure. The pseudo-total concentrations of metals were determined after aqua regia digestion. The analytical accuracy of the method was evaluated by using the Standard Reference Materials (BCR 142R Light Sandy Soil, NIST 2711 Montana Soil, and NIST 2704 Buffalo River Sediment). The sum of the metal contents obtained from the modified BCR sequential extraction procedure and pseudo-total metal contents for soil samples were used to calculate recovery values. In order to evaluate the bioavailability of metals, the relationships between the wheat-metal and soil-extractable metal concentrations were compared.     

Assessment of the Water Quality of Troia for the Multipurpose Usages

The aim of this study was to determine the origin and quality of waters in Troia. For this purpose total of 25 water samples including 2 springs, 14 surfaces and 9 groundwaters, were collected at eight different times. Global positioning system (GPS) was used to determine to coordinates of sampling points. The concentration of 6 minor elements (B, Cu, F, Fe, Pb and Zn), 9 major anions and cations (Na(+), Ca(2+), K(+), Mg(2+), SO(4)(2-), PO(4)(3-), HCO(3)(-), Cl(-) and, CO(3)(2-)) were determined by spectrometric, colorimetric and volumetric methods. Water pH, EC, DO, ORP and TDS were measured in situ using probes. The data showed that the concentrations of most of minor elements were below the EPA and TSE limits except Pb which ranged between 0.001 and 4.832 mg L(-1). Statistically significant relationships (P<0.01 and r>0.70) were observed between Fe and Cu, Cu and K(+), Cu and Ca(2+), B and Na(+), Na(+) and K(+). Assessing the water based on irrigation using Wilcox model showed that some well waters were not suitable for irrigation. Troia water was found to be highly corrosive and the average corrosion coefficients varied from 0.5 to 4.6. According to the Piper and Schoeller diagrams results, the water in Troia was classified as mixed water type.     

Changes in photochemical and antioxidant enzyme activities in maize (Zea mays L.) leaves exposed to excess copper

Changes in photosynthetic and antioxidant activities in maize (Zea mays L.) leaves of cultivars 3223 and 31G98 exposed to excess copper (Cu) were investigated. Cu treatment reduced the shoot and root length of both cultivars. No significant difference of Cu accumulation in the roots of both cultivars was observed while the cultivar 3223 accumulated significantly higher Cu in leaves than 31G98. The observed decreases in effective quantum efficiency of PSII, ETR and qP indicate an over excitation of photochemical system in 3223 compared to 31G98. The leaf chlorophyll and carotenoid contents of both cultivars decreased with increasing Cu concentration. A far higher production of anthocyanins in 31G98 has been observed than that of 3223. At 1.5 mM Cu concentration, all antioxidant enzyme activities increased in leaves of the cultivar 31G98 while there were no significant changes in SOD and GR activities in 3223 compared to the control except increased APX and POD activities. The lower Cu accumulation in leaves and higher antioxidant enzyme activities in 31G98 suggested an enhanced tolerance capacity of this cultivar to protect the plant from oxidative damage.     

Heavy metals in Yeniçağa Lake and its potential sources: soil,water, sediment,and plankton

The distribution and accumulation of heavy metals (Al, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Mo, Cd, Sn, Ba, Pb) in the water, sediments, plankton of Yeniça?a Lake, and its potential sources (creeks, sewage, artesian well, soil) were investigated during 1-year study period as monthly or seasonally. Element analyses were performed by ICP–MS. Results showed that the trace and toxic elements (Al, As, Mn, Pb, Fe) concentration in lake water and/or its feeding sources were above the recommended water standards (WHO, EC, EPA, TS-266). It was found that the maximum accumulation of the heavy metals iron, aluminum, manganese, zinc, and barium in the sediment of Yeniça?a Lake. The accumulation order of trace metals were Fe > Al > Mn > Zn > Ba > Ni > Cr > As > Cu > Pb > Co > Mo > Sn > Cd in the lake, creeks sediment, and soil samples. The similar results suggest that the accumulation of heavy metals in the sediment is a natural process. Metals accumulated in the lake are naturally mixed from the soil. However, the presence of heavy metals in the analysis of artesian well water and sewage reveals that the transportation occurs also from the groundwater to the lake. The results obtained in plankton in Yeniça?a Lake showed that aluminum, iron, manganese, zinc, and barium were most accumulated elements in the plankton. The lower averages of lead prevalent in the water and sediment during some months were seen to have a significant mean accumulation in the plankton.